3D printed Tux
Sunday, July 22, 2012 at 5:51PM 
3D Printed Tux the penguin, the Linux mascot. I printed him on my reprap 3D printer. This little bugger was hard. It took about 10 or so attempts to get right. The bottoms of his little feet start off as islands and they did not want to stick. Finally I put down a thin layer of super glue just before the print started and that got them to stick.
References (1)
References allow you to track sources for this article, as well as articles that were written in response to this article.
-
Response: rushessays3D designs are awesome and you create a tux this is really cute or this work is so difficult. All big man saids that try try again one day you will b succeed and you are 10 time try than you successful to create this design.
Reader Comments